Actions

Ring Tilting

From EastKingdomWiki

This is a simple method for constructing arms to hold rings for ring tilting. This particular set is made to be strapped to the posts of an arena fence though you could easily make some sort of base to hold them up, or use an umbrella base or a pole bending base.

Rings.jpg
Photo by Laura Hamilton

Materials

  • 1.5" PVC for vertical posts
  • 1.25" PVC for arms
  • 1.25" PVC caps for arms
  • 1.5" to 1.25" PVC elbows
  • scrap wood for hangers, 1x3 or 1x4 pine.
  • JB Weld
  • PVC cement
  • 3/4" small round craft magnets
  • brass rings in various sizes, usually found in the floral section of craft stores
  • 3/4" washers
  • electrical tape

Method

NEEDS PICTURES AND MEASUREMENTS - Eleanor

Cut the posts and arms to desired size.

Cut the scrap wood to size. Drill holes sufficient for the 1.25" PVC to slide through easily. JB Weld the craft magnets in place. Cement the elbows onto the arms. Do not cement elbows to posts - you want them to come apart so they're easy to pack. We don't cement the caps on the ends, so we can take them apart and replace the wooden hangers when necessary.

Using a single layer of electrical tape, affix a washer to each brass ring. While the ring will stick to the magnet it tends to blow off in a breeze. The washer gives a greater surface for sticking to the magnet. Use brightly colored tape so it's easier to find the ring on the ground. Decorate as desired. Using a different color for each size of ring makes it a lot easier to tell them apart in the field. Not everyone can eyeball the difference between a 4" ring and a 5".